Another few attempts at 3d printing

As you will see from the images below - I attempted printing my 3d model again twice - each time, it screwed up after about 1 hour and 20-45 minutes. The problem kept arising with the build plate not being sturdy, and so Eliot suggested that perhaps changing the build plate to a thicker one would help. I did this, and thus, it may have fixed it.. (look below to next section of writing)

I have started a new print, and when I left, it had done 20% and looked very promising. I have never had a model get this far whilst printing ( apart from the original prototype I did in a small size.

Lets hope it works..then il have 1/4 done..